Error codes · Bosch
Bosch Dishwasher Error Codes
Bosch dishwashers show codes like E15 or E24, and newer models use four-digit codes like E3100 or E9240. The most common ones are about water in the base and draining. Here is what they mean and what Bosch says you can do.
- 13codes explained
- Checkedagainst Bosch sources
- From $59if you need us
How to read Bosch dishwasher codes
The code appears on the display. On models without a display, Bosch uses combinations of flashing lights instead. Bosch's standard step for electrical and control codes is to switch the breaker off for 30 seconds and back on; if the code stays, the dishwasher needs service.
Code list
Water in the base (leak protection)
Water in the base pan. The leak protection switch has tripped and the dishwasher pumps out and stops.
What to do: Turn off the water to the dishwasher. The water came from somewhere: a hose, seal, pump or excess suds. Drying the base only hides it.
Drain and filter
Blocked filter, blocked or loose drain pump cover, kinked drain hose or clogged air gap.
What to do: Clean the filter, check the drain pump under the filter and reseat its cover until it clicks, straighten the drain hose, clear the air gap, then run a rinse.
Drain pump blocked, clogged or faulty.
What to do: Service needed if cleaning does not clear it.
Same drain causes as E24.
What to do: Same steps as E24.
Water inflow
Flow meter or water inflow problem.
What to do: Call for service.
Water inflow or fill problem.
What to do: Check the inlet hose for kinks or damage.
Water level too low.
What to do: Make sure the water supply is fully on and the hose is not kinked.
Heating, drying and electronics
Heat pump internal heater fault.
What to do: Breaker off 30 seconds; if it stays, service.
Heat pump blocked.
What to do: Breaker off 30 seconds; if it stays, service.
Limescale in the heat pump.
What to do: Descale; use softening salt if your model has a softener.
Crystal Dry (zeolite) fan or heater fault.
What to do: Breaker off 30 seconds; if it stays, service.
Control board circuit faults (heat pump, relays, diverter, door sensor, detergent dispenser).
What to do: Breaker off 30 seconds; if it stays, service.
House voltage too low.
What to do: Reset the breaker; if it returns, have an electrician check the supply.
Before you call
What you can safely try
- Clean the filter and check under it for broken glass or seeds.
- Reseat the drain pump cover until it clicks.
- Straighten the drain hose and clear the air gap.
- Turn the breaker off for 30 seconds.
- Use dishwasher detergent only, never dish soap.
Turn off power before you touch anything inside the dishwasher. If a step needs tools or panels removed, leave it to a technician.
When to call
When it is time for a technician
- E15 again after it was dried (there is a leak).
- E24 or E25 after the filter and pump cover are clean.
- Any heater or control code that survives a breaker reset.
- Water on the floor.
A code tells you where to look, not which part failed. We confirm the cause with tests and readings before we quote. Diagnostic from $59, credited toward the repair. Dishwasher repair · Bosch repair
Denver note
What we see in the Denver area
Denver water is moderately hard. Over a few years that means scale on heaters and spray arms and white film on glasses. On Bosch models with a softener, keep it filled with salt; on others, a descaler a few times a year helps prevent E12-type problems.
Sources
Where this information comes from
Code meanings are checked against Bosch's own published support material and written here in plain language. Models differ, so your owner's manual has the final word.
Pricing
What it costs to get started
One diagnostic fee, credited toward the repair. The full price in writing before any work starts.
Repair prices depend on the part and the labor, so we quote after the diagnosis instead of guessing on the phone. If a repair is not worth it, we will tell you.
Diagnostic visit
from $59
Credited toward the repair
FAQ
Questions we hear
Call (719) 745-8080 with anything not covered here.
How do I reset E15 on a Bosch dishwasher?
Bosch's advice is to turn off the water and call service, not to reset. The water in the base came from a leak or oversudsing, and the cause needs to be found.
What is the difference between E24 and E25?
Both are drain problems. E24 often points to the hose or air gap; E25 more often to the pump area under the filter. Bosch lists the same cleaning steps for both.
Related