These six account for most of our calls. Here is what usually causes them and what our technician actually does about it.
Refrigerator not cooling
Usual causes. A frosted-over evaporator from a failed defrost heater or thermostat, a dead evaporator or condenser fan, a dirty condenser coil, or a compressor start relay that clicks but never lets the compressor run.
What we do. We check fan operation, coil temperatures and the defrost circuit before touching anything sealed. If the system really is low on refrigerant, we find the leak first, pressure-test with nitrogen, pull a vacuum and charge by the factory weight.
Read the full guide · Book this repair
Washer not draining or spinning
Usual causes. A sock or coin in the drain pump, a clogged pump filter, a failed lid lock or door lock, a worn drive belt, or a shift actuator or motor control fault.
What we do. The drain path gets cleared and tested first because that is the cheapest fix. Then we run the service test mode to read the stored codes, check the lock and motor signals, and replace only the part that failed.
Read the full guide · Book this repair
Dryer not heating
Usual causes. An open thermal fuse or high-limit thermostat, a burned heating element on electric dryers, a weak igniter or failed gas valve coils on gas dryers. A blown fuse is usually a symptom of a clogged vent, not the cause.
What we do. We replace the failed part and measure airflow at the vent. If the vent is restricted, we tell you, because a new fuse in a clogged system will just blow again.
Read the full guide · Book this repair
Dishwasher not draining
Usual causes. A packed filter, a blocked air gap or disposal knockout, a kinked drain hose, a jammed drain pump impeller, or a failed check valve.
What we do. We work from the sink back to the pump, clear what is blocked, test the pump under load and run a full cycle before we leave.
Read the full guide · Book this repair
Oven not heating
Usual causes. A weak hot-surface igniter that glows but never opens the gas valve, an open bake or broil element, a failed temperature sensor, or a relay on the control board.
What we do. We measure igniter current and element resistance, check the sensor against a reference, and confirm the oven reaches and holds the set temperature.
Read the full guide · Book this repair
Ice machine not making ice
Usual causes. Scale on the evaporator, a dirty condenser, a stuck water inlet valve, a failed harvest sensor or thickness probe, or a clogged water filter.
What we do. We descale and sanitize when it is needed, verify water flow and harvest timing, and check refrigerant pressures. Production and cube quality are checked before we sign off.
Read the full guide · Book this repair